C 2500 Suburban 2WD V8-454 7.4L VIN J SFI (1998)
Brake Hose/Line: Service and Repair
Front Brake Hose Replacement (2WD)
REMOVAL PROCEDURE
1. Clean the hose fittings at both ends. Remove all dirt, grease, and other foreign material.
2. Disconnect the steel pipe.
3. Remove the clip.
4. Remove the bolt and the washers.
5. Remove the brake hose.
INSTALLATION PROCEDURE
Important: Use new copper washers when installing the brake hose.
Important: After installation, the brake hose must not be twisted. The brake hose must not contact any other components.
1. Install the brake hose. Ensure the hose in not twisted.
2. install new copper washers.
3. Install the bolt.
^
Tighten the bolt to 44 Nm (32 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
