C 2500 Suburban 2WD V8-454 7.4L VIN J SFI (1998)
Parking Brake Drum: Service and Repair
REMOVAL PROCEDURE
1. Release the parking brake.
2. Raise the vehicle and support the vehicle with safety stands.
3. Remove the propeller shaft.
4. Remove the nut and washer if equipped with a manual transmission.
5. Remove the bolt and washer if equipped with an automatic transmission.
6. Disconnect the drum and yoke assembly.
7. Remove the bolts and the washers.
8. Remove the drum from the yoke.
INSTALLATION PROCEDURE
1. Connect the drum to the yoke.
2. Install the bolts and the washers.
^
Tighten the bolts to 37 Nm (27 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Install the drum and the yoke assembly.