C 2500 Suburban 2WD V8-454 7.4L VIN J SFI (1998)
INSTALLATION PROCEDURE
IMPORTANT: The oil pan gasket is reusable. Replace only if the gasket is damaged.
1. Install the oil pan gasket on the oil pan.
2. Install the oil pan gasket and oil pan to the engine block.
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Install the oil pan bolts to the engine block.
Tighten the bolts to 25 Nm (18 ft. lbs.).
4. Install the clutch assembly to the flywheel.
5. Install the flywheel to the crankshaft.
6. Install flywheel inspection cover to the transmission.
7. Install the transmission in the vehicle.
8. Install the starter to the engine block.
9. Install oil cooler line to the retainers.
10. Install the oil filter adapter (4WD) to the cylinder block if equipped.
11. Lower the vehicle.
12. Install the oil level indicator and tube.
13. Fill the crankcase with new engine oil.
14. Connect the battery negative cables to the battery.
15. Close the hood.
