C 2500 Suburban 2WD V8-454 7.4L VIN J SFI (1998)
5.1.
One bolt
5.2.
The vehicle speed sensor
5.3.
The O-ring seal
INSTALLATION PROCEDURE
1. Coat a new O-ring seal with a thin film of transmission fluid. Use Castrol Syntorq GL-4 Transmission Fluid or the equivalent.
2. Install the following parts:
2.1.
The O-ring on the vehicle speed sensor assembly
2.2.
The vehicle speed sensor assembly
2.3.
One bolt
-
Tighten the bolt to 22 Nm (16 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Install the electrical connector on the vehicle speed sensor assembly.
4. Remove the safety stands.
5. Lower the vehicle.
6. Check the transmission fluid level.