C 2500 Suburban 2WD V8-454 7.4L VIN J SFI (1998)
3. Install the wiring harness, manual spring assembly, pressure switch assembly, and all of the remaining valve body bolts.
4. Install the TCC solenoid and bolts.
-
Tighten the bolts to 11 Nm (97 inch lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
5. Install the wiring harness connections to the electrical components. The pressure control solenoid has two different colored connectors. The black
connector should be installed on the tab farthest from the valve body.
6. Install the parking bracket.
-
Tighten the bolts to 31 Nm (23 ft. lbs.).
