C 2500 Suburban 2WD V8-6.5L DSL Turbo VIN F (1995)
Cruise Control Servo Cable: Service and Repair
Fig. 16 Cruise control module & cable replacement
Removal
1. Unfasten retainer clip, then remove engine end fitting from lever stud.
2. Remove cable conduit from engine bracket and module housing.
3. Remove cable bead from end of ribbon fitting on cruise module.
Installation
1. Connect cable bead to ribbon fitting on cruise module.
2. Position cable conduit over ribbon fitting and insert tangs into module housing. Pull engine end fitting until cable is snug, then rotate cable to
position ribbon fitting flat and vertical. The ribbon must not be twisted.
3. Install cable conduit into engine bracket.
4. Unlock cable conduit, then connect engine end fitting of cable to lever stud.
5. Install retainer clip. Secure cable conduit by firmly depressing lock until it snaps into place.
