C 2500 Suburban 2WD V8-6.5L DSL Turbo VIN F (1995)
Water Pump: Service and Repair
Water pump installation
1. Drain coolant from radiator, then remove fan shroud.
2. Remove drive belt, then the A/C hose bracket.
3. Remove oil fill tube, fan, fan clutch and pulley from coolant pump.
4. Disconnect bypass hose and lower radiator hose.
5. Remove water pump mounting bolts and plate, then the water pump.
6. Reverse procedure to install. Before installing bolts, apply anaerobic sealer part No. 0.052357, or equivalent, to sealing surface as shown,
Fig. 12. Sealer should be wet to touch before installing bolts. Tighten attaching bolts to specifications.
