C 2500 Suburban 2WD V8-6.5L DSL Turbo VIN F (1995)
Fully engage the knurled tangs of Seal Remover-Installer J 23128-A into the recessed portion of the Seal by turning the handle clockwise. Remove
the Seal from the compressor with a rotary-pulling motion. Discard the Seal. The handle must be hand-tightened securely. Do not use a wrench or
plier.
7. Remove and discard the seal seat O-ring from the compressor, neck using O-Ring Remover J 9553-01.
8. Recheck the shaft and inside of the compressor neck and O-ring groove for dirt or foreign material and be sure these areas are perfectly clean
before installing new parts.
Inspection
Seals should not be reused. Always use a new specification service seal kit on rebuild. Care should be taken to prevent damage to the lip of the one piece
seal. Make sure that the Seal Seat and Seal Lip are free of lint and dirt that could damage the seal surface or prevent sealing.
