C 2500 Suburban 2WD V8-6.5L DSL Turbo VIN F (1995)
2. Lead wire to #8 glow plug.
3. Glow plugs into cylinders #2, #4, and #6.
^
Install the glow plugs by reaching through the right wheel well.
Tighten
^
Glow plugs to 17 Nm (13 lb. ft.).
4. Lead wire to glow plug #6.
^
Slide the shroud over the wire lead and fasten to the studs.
-
Repeat Step 4 for the #4 glow plug.
Tighten
^
Heat shroud nuts to 23 Nm (17 lb. ft.).
5. Wires for glow plugs #4 and #6 to connectors at the wire harness.
6. Lead wire for #2 glow plug.
INSPECT
^
Wire routing, making sure the lead wires are not rubbing against the exhaust manifold or any part that may harm the wire insulation.
7. Splash shield in the right wheel well.
8. Right front tire.
^
Refer to Wheel and Tires/Steering and Suspension for lug nut torque.