C 2500 Suburban 2WD V8-6.5L DSL Turbo VIN F (1995)
RETRACTOR REMOVAL PROCEDURE: (Figure 2)
1.
Remove the anchor bolt cover from the door "B" pillar anchor plate. The cover swings bottom upward.
2.
Remove anchor bolt from door "B" pillar weld nut.
3.
Remove the anchor bolt retaining the seat belt retractor to the floor. To access the bolt, remove the access cover on the back side of retractor. This
cover is removed from the top and is swung outward.
4.
Remove the retractor/belt assembly.
Installation Procedures:
1.
Install retractor system to the floor. When installing the anchor bolt, start the bolt by hand to ensure that the bolt is threaded straight. After bolt has
been started, torque bolt to 55 Nm (41 lb. ft.). Close the cover.
IMPORTANT:
Before attaching the anchor plate to the door "B" pillar, make sure that the seat belt webbing is not twisted.
2.
Install anchor bolt through the anchor plate and washer. When installing anchor bolt into weld nut located at the "B" pillar, start the bolt by hand
to ensure that the bolt is threaded straight. After bolt has been started, tighten bolt and torque bolt to 55 Nm (41 lb. ft.).
3.
Install cover over the door "B" pillar anchor plate.
4.
Install Campaign Identification Label.
SERVICE PROCEDURE "B"
For 1994-1995 C/K With Any Gas Engine, Or L65 H.O. 6.5L Turbo (VIN Code F) Diesel Engine
This procedure addresses removal of stitching from the Energy Management (EM) loop, in the shoulder belt side of the seat belt assembly on 1994-1995
C/K With Any Gas Engine, Or L65 H.O. 6.5L Turbo (VIN Code F) Diesel Engine. This procedure MUST NOT be done to the lap belt side.
*
For 1994 models: Remove stitching from the shoulder belt EM loop on both the Driver and Passenger seat belt assemblies.
*
For 1995 models: Remove stitching from the shoulder belt EM loop on the Passenger seat belt assembly ONLY.
IMPORTANT:
