C 2500 Suburban 2WD V8-6.5L DSL Turbo VIN F (1995)
Power Steering Bleeding: Service and Repair
Fig. 2 Power Steering System Bleed Chart
1. Fill pump fluid reservoir to proper level and let fluid settle for at least two minutes.
2. Start and run engine for a few seconds. Do not turn steering wheel.
3. Turn engine OFF. Check fluid level, add fluid if necessary.
4. Repeat above procedure until fluid level remains constant after running engine.
5. Raise front end of vehicle so wheels are off ground.
6. Start engine. Slowly turn steering wheel in both directions, lightly contacting wheel stops.
7. Add power steering fluid, if necessary.
