C 2500 Suburban 2WD V8-6.5L DSL Turbo VIN F (1995)
Clutch Slave Cylinder: Service and Repair
Removal and Installation
When servicing the clutch actuator with hydraulic line intact, disconnect the clutch master cylinder pushrod from the clutch pedal in order to prevent
damage to the actuator should the pedal be depressed.
1. Raise and support vehicle, then remove actuator cylinder to clutch housing nuts and actuator assembly.
2. Use hydraulic clutch line separator tool No. J-36221 or equivalent to disconnect actuator cylinder hydraulic line coupling, then remove line from clips
if necessary.
3. Reverse procedure to install, noting the following.
