C 2500 Suburban 2WD V8-6.5L DSL Turbo VIN F (1995)
Clutch Assembly And Pilot Bearing
11. Pilot bearing if it is worn or damaged. Use J 23907 or J 38149 as needed.
CLEAN
1. All parts with a clean, water dampened cloth to remove any fibers.
2. Clutch fork, clutch housing, and ball stud with solvent Wipe dry.
NOTICE: The release bearing is permanently packed with lubricant and should not be soaked in cleaning solvent since this will dissolve the
lubricant.
INSPECT
-
All parts for wear and damage.
-
Contact surfaces for scoring and flatness with a straight edge.
-
Friction pads for scoring, gouges, and loose rivets. Check to see if they are oil soaked.
-
All splines for nicks, burrs, and sliding fit.
-
All springs for bending and breaks.
-
Boot for tears and brittleness.
MEASURE
-
Transmission pilot hole in the clutch housing for runout using a dial indicator. Runout should not be more than 0.380 mm (0.015 inch).
