C 2500 Suburban 2WD V8-6.5L DSL Turbo VIN F (1995)
8.
Carefully apply a bead of silicone sealant, P/N 12345739 (or GE-162 sealant or equivalent) in the groove of the NEW cover (Figure 2). Remove
any excess sealant that is outside of the groove.
Important
Only apply enough sealant to fill the groove in the cover.
9.
Install the new cover on the wiper motor housing and install the three new screws. Tighten the screws to 2.6 Nm (23 lb in).
10.
Reconnect the wiper motor electrical connector to the wiper motor assembly and install the CPA.
11.
Turn the ignition key to the ON position and check the wiper system for proper operation (delay/low/high/etc.).
CLAIM INFORMATION
For vehicles repaired under the terms of this special policy, submit a claim with the information indicated.
CUSTOMER REIMBURSEMENT
Customer requests for reimbursement of previously paid repairs to correct a failed wiper motor are to be submitted prior to or by February 29, 2004 (this
time limitation may be longer depending upon the law in your state/province/country). Repairs must have occurred before March 14, 2003.
When a customer requests reimbursement, they must provide the following:
-
Proof of ownership at time of repair.
