C 2500 Suburban 2WD V8-8.1L VIN G (2001)
Important:
^
Prior to the installation of the engine oil cooler hose/pipe assembly, install NEW retaining clips to the quick connect fittings.
^
Ensure that the oil cooler hose/pie assembly being installed has plastic caps on the ends of the pipes. If no plastic caps exist, or the plastic cap is
damaged, obtain a new cap. Install the cap on to the cooler line prior to cooler line installation.
1. Do not install the NEW retaining clips onto the fitting by pushing on the clip.
Important: Failure to properly install the retaining clip could cause the cooler line to come loose and cause damage to the engine.
2. Install the NEW retaining clip into the quick connect fitting by using your thumb and forefinger. Insert the new retaining clip into one of the three
fitting recesses. Ensure that the retaining clip is engaged in all 3 slots.
3. With one end of the retaining clip engaged in the connector fitting slot, use your thumb in order to rotate the retaining clip around the connector
fitting, until the retaining clip snaps into place.
4. Ensure that the 3 retaining clips ears are seen from inside the fitting and that the retaining clip moves freely in the fitting slots.
