C 2500 Suburban 2WD V8-8.1L VIN G (2001)
^
MAP sensor (1)
^
Ignition coil harness (2)
^
ECT sensor (3)
40. Install the CPA retainer at the ignition coil harness.
41. Position engine harness branch over the top of engine.
42. Connect the following electrical connectors:
^
Pressure cycling switch (1)
^
Surge tank switch (2)
^
MAF sensor (3)
43. Connect the engine harness clip to the wheelhouse splash shield.
44. Connect the engine harness clips to the studs on the front of dash.
45. Connect the fuel feed and return pipes.
46. Install the sight shield bracket (1) and nuts.
^
Tighten the sight shield bracket nuts to 5 Nm (44 inch lbs.).
47. Install the sight shield to the bracket (1).
48. Tighten the intake manifold sight shield bolt (3).
^
Tighten the intake manifold sight shield bolt to 10 Nm (89 inch lbs.).
