C 2500 Suburban 2WD V8-8.1L VIN G (2001)
Important: Install the adjustment bolt the same amount of turns that were required to remove the bolt during removal.
8. Install the adjustment bolt (3) and the adjuster nut (4).
9. Install the adjustment bolt (3) and the adjuster nut (4) (K 25/35 Series with MT1, MW3, C5F and COP).
10. Remove the J 36202 releasing the tension on the torsion bar until the load is taken up by the adjustment bolt.
11. Remove the safety stands.
12. Lower the vehicle.
13. Measure the Z height. Refer to Trim Height Inspection Procedure.
14. Turn the adjustment bolt (2) clockwise to increase the Z height and counterclockwise to decrease the Z height.