C 2500 Truck 2WD V6-262 4.3L VIN Z (1992)
Transmission case using a solvent dampened cloth. Do not allow solvent to enter the transmission. Air dry.
All hardware and flywheel cover using solvent. Air dry.
Inspect
-
All parts for wear and damage.
-
All seals and fittings for signs of leakage.
-
Torque converter for stripped or broken weld nuts or screw holes.
-
Transmission case for porosity.
Install
-
If the transmission was lowered for clearance only, perform steps 13-20.
Tool Required:
J 21366 Converter Holding Strap
1. Transmission (225).
-
Be sure the torque converter is seated properly and that J 21366 is in place.
-
Support the transmission, and the transfer case if used, with a transmission jack.
-
Raise the transmission into place and remove J 21366.
-
Slide the transmission straight onto the locating pins (A) while lining up the marks on the flywheel and the torque converter.
