C 2500 Truck 2WD V8-305 5.0L VIN M SFI (1997)
Oil Pan: Service and Repair
Oil Pan Installation
1. Apply sealant GM P/N 12346004 or the equivalent to the front cover to block joint. Apply the sealant for about 25 mm (1 inch), in both directions
from each of the four corners.
2. Apply sealant GM P/N 12346004 or the equivalent to the rear crankshaft seal to block joint. Apply the sealant for about 25 mm (1 inch) in both
directions from each of the four corners.
3. Install the oil pan gasket to the oil pan.
4. Install the oil pan to the engine.
5. Install the oil pan bolts, nuts, and strut rods (if equipped).
^
Tighten the oil pan bolts and nuts to 25 Nm (18 ft. lbs.).
6. Install the oil filter adapter.
7. Install the oil filter.
8. Install the transmission oil cooler line retainer to the bracket (automatic transmission only).
9. Install the flywheel/torque converter inspection cover. Refer to Transmission and Drivetrain.
10. Install the exhaust crossover pipe. Refer to Exhaust System.
11. Remove the safety stands.
12. Lower the vehicle.
13. Install the oil level indicator.
