C 2500 Truck 2WD V8-305 5.0L VIN M SFI (1997)
CAUTION: In order to prevent possible Electrostatic Discharge damage to the VCM, do not touch the connector pins or soldered components on the
circuit board.
8. Proceed to the EEPROM programming.
REPROGRAMING (FLASHING) THE CONTROL MODULE
Some vehicles allow the reprogramming of the control module without removal from the vehicle. This provides a flexible and a cost-effective method of
making changes in software and calibrations. Refer to the latest Techline information on re-programming or flashing procedures.
