C 2500 Truck 2WD V8-305 5.0L VIN M SFI (1997)
Slip Ring End Frame With Starter Removed
8. Brush holder, regulator, and connector assembly into the end frame.
-
The metal side of the capacitor strap should rest against the regulator connection.
9. One bolt into the brush holder.
-
If a brush holder with locator bosses is being replaced with a holder without locators, make sure to align the brush holder assembly and hold it
with your fingers while tightening the brush holder attaching screw.
10. Two insulated screws through the regulator connector.
Stator Installed In The Slip Ring End Frame
11. Stator into the end frame, aligning the three stator leads to the three rectifier bridge terminals.
12. Three rectifier bridge nuts. Tighten the nuts securely.
Drive End Frame
Regulator Connections
