C 2500 Truck 2WD V8-305 5.0L VIN M SFI (1997)
Axle Shaft Assembly: Service and Repair
Full-Floating Axle (10 1/2 Inch Ring Gear)
REAR DRIVE AXLE
REMOVE OR DISCONNECT
1. Bolts.
-
Rap the axle shaft flange lightly with a soft-faced hammer to loosen the shaft.
-
Grip the rib on the axle shaft flange with a locking plier and twist, to start shaft removal.
2. Axle shaft from the tube.
Clean
-
Axle shaft flange. Remove old RTV or gasket.
-
Outside face of the hub assembly.
-
All parts and replace as necessary.
INSTALL OR CONNECT
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application.
The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require
thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors
on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may
damage the fastener. When you Install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you
avoid damage to parts and systems.
1. Axle shaft with a gasket or RTV applied.
-
Be sure the shaft splines mesh into the differential side gear.
-
Align the axle shaft holes with the hub holes.
2. Bolts.
-
Tighten bolts to 150 Nm (110 ft. lbs.).
