C 2500 Truck 2WD V8-6.5L DSL Turbo VIN S (1997)
Caliper To Bracket Clearance
7. Measure clearance between caliper (12) and bracket stops (16). If necessary, remove caliper and file the ends of bracket (16) to obtain 0.26 to 0.60
mm (0.010 to 0.024 inch) total clearance. Measure the clearances individually and add them together.
8. Tire and wheel.
NOTE: Before moving the vehicle, pump the brake pedal several times to make sure it is firm. Do not move the vehicle until a firm pedal is obtained.
Check the fluid level in the master cylinder after pumping the brakes.
3486 Caliper
Remove or Disconnect
1. Two-thirds of the brake fluid from master cylinder.
2. Raise vehicle and support with safety stands.
3. Tire and wheel.
^
On models with composite rotor, reinstall two lug nuts to retain rotor.
Compressing Piston Prior To Caliper Removal
4. Compress piston using adjustable pliers over inboard lining (7) tab and caliper housing flange (12).
