C 2500 Truck 2WD V8-6.5L DSL Turbo VIN S (1997)
Seating The Boot In The Housing
4. Piston (9) and boot into caliper bore.
a. Push piston to the bottom of bore.
b. Seat boot in housing using tool No. J 36474, J 36475, J 38453 or equivalent.
5. Bleeder valve (11).
^
Tighten bleeder valve (11) to 13 Nm (115 inch lbs.).
Delco 3486
Tools Required:
J 36474-75 mm Boot Seal Installer or
J 36475-80 mm Boot Seal Installer or
J 38453-86 mm Boot Seal Installer
Caliper Components
Remove or Disconnect
1. Fluid from the caliper.
2. Pad the interior of the caliper with clean shop towels.
WARNING: Do not place your fingers in front of the piston in an attempt to catch, or protect it when applying compressed air. This could result
In serious Injury.
CAUTION: Use just enough air to ease the piston out of the bore. If the piston is blown out, even with the padding, It can be damaged.