C 2500 Truck 2WD V8-6.5L DSL Turbo VIN S (1997)
Lifter / Lash Adjuster: Service and Repair
Replacement, Engine Overhaul
REMOVAL
NOTE: When removing the valve lifters place the lifters in an organizer rack. The lifters must be installed in the same bore from which these were
removed.
1. Remove the bolts and the valve lifter retaining clamps.
2. Remove the valve lifter guide plates.
3. Remove the valve lifters.
INSTALLATION
CAUTION: Prime the new valve lifters before Installation. The valve lifters may be damaged if the valve lifters are dry when the engine is started.
NOTE: Replace the lifters when you Install a new camshaft. Some engines will have both standard and 0.25 mm (0.010 inch) oversize valve lifters. The
oversize lifter will have the number 10 etched on the side. The block will be stamped OS on the cast pad adjacent to the lifter bore and on the top rail of
