C 2500 Truck 2WD V8-6.5L DSL Turbo VIN S (1997)
Oil Pressure Switch (For Fuel Pump): Service and Repair
Description
REMOVAL PROCEDURE
1. Remove the Fuel Filter/Manager. Go to Fuel Manager/Filter Replacement. See: Tune-up and Engine Performance Checks/Fuel Filter/Service
and Repair
2. Disconnect the electrical connector.
3. Remove the switch using J 35748.
INSTALLATION PROCEDURE
1. Install the Fuel Filter/Manager. Go to Fuel Manager/Filter Replacement. See: Tune-up and Engine Performance Checks/Fuel Filter/Service and
Repair
2. Install the switch.
3. Connect the electrical connector.
4. Bleed the fuel system. Refer to Bleeding Air from Fuel Supply System. See: Powertrain Management/Fuel Delivery and Air Induction/Service
and Repair
