C 2500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2001)
7. Place the cushion on the rear plastic holders (1) on the underside of the seat cushion, and push rearward.
8. Connect the lumbar cable to the underside of the seat cushion (6). Connect the lumbar wire harness (if equipped with power lumbar).
9. Connect the electrical connectors.
Notice: Refer to Fastener Notice in Service Precautions.
10. Install the front nuts (2) onto the studs on the underside of the cushion.
Tighten the nuts to 21 N.m (15 lb ft).
11. Feed the seat belt through the seat cushion.
12. Install the outboard seat belt anchor nut.
Tighten the nut to 53 N.m (39 lb ft).
13. Install the seat trim panel.
