C 2500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2001)
8. If equipped with RPO C36 (auxiliary heater), install the surge tank/heater outlet hose (1) to the mounting clip.
9. If equipped without RPO C36 (auxiliary heater), install the surge tank/heater outlet hose (1) to the mounting clip.
Important: Align the arrow at the throttle body end of the duct with the throttle body attaching stud.
10. Install the air cleaner outlet duct.
11. Install the radiator inlet hose clip to the outlet duct.
Notice: Refer to Fastener Notice in Service Precautions.
12. Tighten the air cleaner outlet duct clamps at the following locations:
^
Throttle body
^
MAF/IAT sensor
^
Tighten the air cleaner outlet duct clamp screws to 7 Nm (62 inch lbs.).