C 2500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2001)
1. Connect the evaporator tube to the condenser using new sealing washers.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the evaporator tube nut to the condenser.
Tighten
Tighten the nut to 16 N.m (12 lb ft).
3. Install the grille to the vehicle.
4. Install the right park/turn signal lamp.
5. Connect the evaporator tube to the auxiliary A/C tube using new sealing washers (if equipped).
6. Install the evaporator tube nut to the auxiliary A/C tube (if equipped).
Tighten
Tighten the nut to 16 N.m (12 lb ft).
7. Connect the evaporator tube to the evaporator.
8. Install the evaporator tube nut to the evaporator.
Tighten
Tighten the nut to 16 N.m (12 lb ft).
9. Evacuate and recharge the system. Refer to Refrigerant Recovery and Recharging.
10. Leak test the fittings of the components using the J 39400-A.
A/C Suction Hose/Line
