C 2500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2001)
Power Steering Pressure Control Valve: Service and Repair
PS Solenoid Actuator, Discharge Fitting Replace
PS Solenoid Actuator, Discharge Fitting Replace
Removal Procedure
1. Remove the electrical connector from the power steering solenoid actuator (1).
2. Remove the power steering pump (1) from the vehicle. Refer to Power Steering Pump Replacement.
3. Remove the retaining ring (2) from the power steering solenoid actuator (1).
Important: Note the orientation of the power steering solenoid actuator discharge fitting.
4. Remove the power steering solenoid actuator (1) and fitting.
5. Remove the O-ring seal from the power steering solenoid actuator.
Installation Procedure
Important: Note the orientation of the power steering solenoid actuator discharge fitting.
