C 2500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2001)
9. Remove the shock absorber mounting bolts at the lower control arm.
10. Remove the shock absorber through the lower control arm from below.
Installation Procedure
1. Support the lower control arm with a suitable jack in order to align the tennon with the mounting hole if equipped with selectable ride.
2. Install the shock absorber through the lower control arm from below. Insert the tennon through the mounting hole in the upper spring pocket.
3. Align the shock absorber with the mounting holes in the lower control arm.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the shock absorber mounting bolts to the lower control arm.
-
Tighten the bolts to 25 Nm (18 ft. lbs.).
