C 2500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2001)
5. Install the pawl return spring.
6. Install the detent lever to the actuator assembly.
7. Install actuator assembly over the parking pawl.
8. Install the manual shaft seal.
9. Lubricate the manual shaft with transmission oil and install the manual shaft into the case.
10. Install the nut on the shaft.
11. Install the roll pin.
Notice: Refer to Fastener Notice in Service Precautions.
12. Install the parking lock bracket with the two bolts.
^
Tighten the bolts to 24 Nm (18 ft. lbs.).
13. Install the park/neutral position switch.
14. Install the oil pan and filter.
15. Lower the vehicle.
16. Fill the transmission to the proper level with Dexron III transmission fluid.
