C 2500 Truck 2WD V8-8.1L VIN G (2002)
5. Install the lower bolts to the rear of the fender.
Tighten the bolts to 25 Nm (18 lb ft).
6. Install the bolts in order to retain the fender to the rear pillar.
Tighten the bolts to 23 Nm (17 lb ft).
7. Install the rear taillamp assembly to the vehicle. Refer to Tail/Turn Signal Lamp Replacement (Except Stepside) Tail/Turn Signal Lamp
Replacement (Stepside) in Lighting Systems.
8. Install the bolts to the front of the fender.
Tighten the bolts to 23 Nm (17 lb ft).
9. Install the fuel filler neck to the vehicle, if removed. Refer to Fuel Tank Filler Door Replacement (See: Doors, Hood and Trunk/Fuel
Door/Service and Repair/Removal and Replacement).
