C 2500 Truck 2WD V8-8.1L VIN G (2002)
17. Route the deployment harness out of the vehicle's driver side.
18. Disconnect the inflatable restraint IP module connector (1) located behind the main IP support. Access the connector by opening the glove box and
pressing in on the sides. This will allow the glove box to extend beyond the stops and to fully open. The IP module connector will be attached to
the main IP support.
19. Cut the LF side impact module harness connector out of the vehicle leaving at least 16 cm (6 in) of wire at the connector.
20. Strip 13 mm (0.5 in) of insulation from each of the LF side impact module connector wire leads.
