C 2500 Truck 2WD V8-8.1L VIN G (2002)
1. Remove the torque converter from the transmission.
2. Remove any of ten bolts (1) (bolt heads shaded) where leakage at the bolt head is suspected.
Important: Bolts (1) have a removable seal under the flanged head.
3. Remove and discard seals from bolts removed.
Installation Procedure
1. Install new seals on any bolts (1) removed.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install any bolts (1) removed.
^
Tighten bolts to 56 Nm (41 ft. lbs.).
3. Install the torque converter into the transmission.
Seal Replacement - Torque Converter
Seal Replacement - Torque Converter
^
Tools Required
-
J 24171-A Seal and Dust Shield Remover
-
J 43772 Torque Converter Seal Installer
Removal Procedure
