C 2500 Truck 2WD V8-8.1L VIN G (2002)
2. If required, install the following:
2.1.
The yoke
2.2.
A NEW main shaft washer
2.3.
A NEW prop shaft yoke washer
2.4.
The main shaft nut
3. If required, use J 8614-01 in order to keep the keep yoke from rotating.
Notice: Refer to Fastener Notice in Service Precautions.
4. Tighten the main shaft nut.
^
Tighten the main shaft nut to 441 Nm (325 ft. lbs.).
5. Install the rear propeller shaft.
6. Check the transmission fluid level. Add if necessary.
7. Lower the vehicle.
