C 30 P/U 2WD V8-379 6.2L DSL (1985)
dash).
6.
Install wires at roof access holes into plug sockets.
7.
Lubricate lamp pad socket opening with rubber lubricant and insert the socket into the pad.
8.
Insert bulbs into sockets.
9.
Install clips (nuts) over the screw holes.
10.
Position light pads over holes previously drilled and install the lens using the attaching screws with nylon washers.
11.
Install black connector on ground wire under dash and plug into ground bus bar.
12.
Insert positive lead into headlight switch as indicated. Refer to Figure #2.
Location is open position beside green wire.
13.
Reconnect negative battery cable.
14.
Test marker lamp operation by pulling head lamp switch.
15.
Install campaign label.
PARTS INFORMATION
Parts kits required to complete this campaign are to be obtained by the dealer from the Chevrolet Zone Service Department. Parts kits will be
furnished on a no charge basis.
Parts are not to be ordered from or returned to the Warehousing Distribution Division of General Motors (WDDGM).
CLAIM INFORMATION
Submit a Product Claim with the information indicated below:
Failure
Labor
Labor
*Other
Code
Operation
Hours
Hours
00
V2590
.2
.1
Description:
Inspect for roof marker lamps. Lamps already installed, no further action required.
Failure
Labor
Labor
*Other
Code
Operation
Hours
Hours
00
V2591
1.2
.1
Description:
Inspect for roof marker lamps and install missing roof marker lamps per Service Procedure.
*Campaign Administrative Allowance.
Dealers will automatically receive the correct labor allowance based on the labor operation performed. Dealers will likewise receive 30% of net only for
parts furnished at no charge by Chevrolet. (DMN $12.30).
Refer to the Chevrolet Claims Processing Manual for details on Product Campaign claim submission.
CAMPAIGN IDENTIFICATION LABEL
CAMPAIGN IDENTIFICATION LABEL
