C 3500 HD Truck 2WD V8-8.1L VIN G (2002)
5. Remove the rubber cap or plug from the exposed brake pipe fitting end.
6. Connect the brake pipe fitting nut to the brake hose:
^
Use a backup wrench on the hose fitting.
^
Do not bend the bracket or the pipe.
Tighten
Tighten the bolt to 25 Nm (18 ft. lbs.).
7. Ensure that the hose does not make contact with any part of the suspension. If the hose makes contact, remove the hose and correct the condition.
8. Bleed the hydraulic brake system.
9. Lower the vehicle.
