C 3500 HD Truck 2WD V8-8.1L VIN G (2002)
1. Use the J 26549-E in order to install the expansion tube (3) into the condenser outlet pipe (2).
2. Install the new O-ring seal.
2.1.
Coat the O-ring seal with 525 viscosity refrigerant oil.
2.2.
Insert the short screen end of the new orifice into the evaporator tube.
3. Install the evaporator tube to the condenser.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the evaporator tube nut to the condenser.
Tighten
Tighten the nut to 20 N.m (15 lb ft).
5. Install the grille.
6. Evacuate and recharge the system. Refer to Refrigerant Recovery and Recharging.
7. Leak test the fitting(s) of the repaired or reinstalled component using the J 39400-A.
For a description of the RPO Code(s) shown in this article/images refer to the RPO Code List found at Vehicle/Application ID See: Application and
ID/RPO Codes
