C 3500 HD Truck 2WD V8-8.1L VIN G (2002)
Fuel: Testing and Inspection
Alcohol In Fuel Testing Procedure
The fuel sample should be drawn from the bottom of the tank so that any water present in the tank will be detected. The sample should be bright and
clear. If alcohol contamination is suspected then use the following procedure to test the fuel quality.
1. Using a 100 ml specified cylinder with 1 ml graduation marks, fill the cylinder with fuel to the 90 ml mark.
2. Add 10 ml of water in order to bring the total fluid volume to 100 ml and install a stopper.
3. Shake the cylinder vigorously for 10-15 seconds.
4. Carefully loosen the stopper in order to release the pressure.
5. Re-install the stopper and shake the cylinder vigorously again for 10-15 seconds.
6. Put the cylinder on a level surface for approximately 5 minutes in order to allow adequate liquid separation.
If alcohol is present in the fuel, the volume of the lower layer, which would now contain both alcohol and water will be more than 10 ml. For example, if
the volume of the lower layer is increased to 15 ml, this indicates at least 5 percent alcohol in the fuel. The actual amount of alcohol may be somewhat
more because this procedure does not extract all of the alcohol from the fuel.
