C 3500 HD Truck 2WD V8-8.1L VIN G (2002)
Camshaft Position Sensor: Service and Repair
REMOVAL PROCEDURE
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
2. If the vehicle is equipped with the underbody shield package, remove the steering linkage shield.
3. Disconnect the camshaft position (CMP) sensor harness connector (3) at the CMP sensor (1).
4. Remove the CMP sensor retaining bolt (2).
5. Remove the CMP sensor (1).
6. Inspect the CMP sensor for wear, cracks, or leakage if the sensor is not being replaced.
INSTALLATION PROCEDURE
IMPORTANT: Inspect the CMP sensor O-ring for wear or damage. If a problem is found, replace the O-ring.. Lubricate the new O-ring with engine
oil before installing.
1. Install the CMP sensor (1).
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the CMP sensor retaining bolt (2).
Tighten
Tighten the bolt to 12 N.m (106 lb in).
3. Connect the CMP sensor harness connector (3).
4. Install the steering linkage shield, if equipped.
5. Lower the vehicle.
