chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Clutch - Chatter/Shudder On Launch Condition|Page 4793 > < M/T - Neutral Gear Rattle, New PROM & Clutch|Page 4788
Page 1
background image

Clutch Disc: Customer Interest
Clutch - Chatter/Shudder On Launch Condition

Number:

91-304-7C

Section:

7C

Date:

MAY 1991

Corp. Bulletin No.: 167302

Subject:

CLUTCH CHATTER/SHUDDER ON LAUNCH

Model and Year:

1988-91 C/K TRUCKS WITH 4.3L OR 5.0L ENGINES AND 4-SPEED OR 5-SPEED MANUAL TRANSMISSION

Some 1988-91 C/K trucks equipped with 4.3L or 5.0L engines with 4-speed or 5-speed manual transmissions may experience a condition of chatter or
shudder on launch.

Revised clutch discs and matching pressure plates have been released for these vehicles and are available through GMSPO. The clutch discs feature a
revised facing material which will provide smoother engagement and increased wear resistance. These revised discs can be identified by the name stamp
Valeo while the previous discs were stamped Borg Warner. The pressure plates have been revised to work with the discs and must be replaced at the
same time. The revised pressure plates will be marked with the name stamp Luk while the previous pressure plate may be marked with the name stamp
Luk or Borg Warner.

The installation of these parts will provide significant improvement in the involved vehicles.

VEHICLES INVOLVED

Some 1988-91 C/K trucks equipped with 4.3L or 5.OL engines and 4-speed or 5-speed transmissions built prior to the following VIN breakpoints:

4.3L / 5.0L

Fort Wayne (Z)

MZ159936

Oshawa (1)

M1178933

Pontiac (E)

ME152577

SERVICE PROCEDURE

The pressure plate and clutch disc should be replaced at the same time as the parts have been designed to work together. Refer to section 7C of the
appropriate service manual for clutch disc and pressure plate replacement procedure.

IMPORTANT:

Before removing the existing pressure plate, note the location of the paint dab on the pressure plate cover. This paint dab indicates the
heavy side of the pressure plate assembly and is aligned with the light side of the engine at the assembly plant. The new pressure plate
should be installed with the paint dab in the same location to preserve the balance of the engine assembly.

SERVICE PARTS INFORMATION

PRESSURE

CLUTCH

ENGINE

TRANSMISSION

PLATE P/N

DISC P/N

4.3L

4 or 5 SPEED

15668537

15668527

5.0L

5 SPEED

15668537

15668527

Parts are currently available from GMSPO.

WARRANTY INFORMATION
For vehicles repaired under warranty use:

Labor Operation

Models

K0800

C1 C2 C3

K0800

K1 K2 K3

Add

K1 K2 K3

with skid plate

Clutch - Chatter/Shudder On Launch Condition|Page 4793 > < M/T - Neutral Gear Rattle, New PROM & Clutch|Page 4788