C 3500 Truck 2WD V8-379 6.2L DSL (1988)
Turn Signal Switch: Service and Repair
1.
Disconnect battery ground cable.
2.
Remove steering wheel.
3.
Remove instrument panel trim cover.
4.
Remove lock plate.
5.
Remove turn signal lever screw and lever.
6.
Remove hazard warning knob.
7.
Remove turn signal switch attaching screws.
8.
Disconnect electrical connector from turn signal switch.
9.
Remove wire protector.
10.
Position turn signal and shifter housing in the low position. Remove harness cover by pulling toward the lower end of the column. Ensure not to
damage the wires on tilt column models.
11.
Remove turn signal switch.
12.
Reverse procedure to install.
