C 3500 Truck 2WD V8-379 6.2L DSL (1988)
b. Position four (4) attaching bolts (pointing downward), washers and nuts.
c. Tighten nuts (B) to 60 N-m (45 lb.ft.).
16.
Install new lower ball joint (Fig. 10, 127) to knuckle (Fig. 10, 117). Drive axle should be installed through hub assembly at same time.
17.
Install stud nut (Fig. 10, 131) and new cotter pin (Fig. 10, 130).
a. Tighten stud nut to 128 N-m (94 lb.ft.).
b. Align slot in stud nut with hole in stud.
c. Bend cotter pin ends against nut.
18.
Install upper ball joint (Fig. 10, 115) to knuckle (Fig. 10, 117).
19.
Install stud nut (Fig. 10, 129) and new cotter pin (Fig. 10, 130).
a. Tighten stud nut (Fig. 10, 129) to 100 N-m (75 lb.ft.).
b. Align slot in stud nut with hole in stud.
c. Bend cotter pin ends against nut.
20.
Install washer (Fig. 10, 119) and drive axle nut (Fig. 10, 120). Tighten nut to 235 N-m (173 lb. ft.).
21.
Install brake rotor and caliper.
22.
Install wheel and tire assembly.
23.
Repeat procedure on opposite side of vehicle.
Claim Information
Submit a claim with the information indicated below. Verify part numbers to year/application:
1988-1989 Models
*
FAILED
PARTS
CC-FC
LABOR
LAB
REPAIR PERFORMED
PC
PART NO.
ALLOW
OP
HRS
1988-89 C Truck Uppers
2
15659518 or
**
NR-95
T7306
1.1
Replace 2 Ball Joints
15634909
1988-89 C Truck -
4
15657212
**
NR-95
T7306
1.5
Replace 4 Ball Joints
1988-89 K Truck -
4
15634942
**
NR-95
T7306
3.9
Replace 4 Ball Joints
Alignment Parts Kit
1
15654867
**
VM-95
T7309
0.0
Supplied To Customer
* Times should be added or deleted as necessary from the applicable Labor Hours.
1988-89 C/K Truck Times
Add:
To Check & Adjust Front Wheel Toe-in Alignment 0.3 Hours
Delete:
For EACH previously installed ball joint 0.1 Hours.
1990 Models