C 3500 Truck 2WD V8-6.0L VIN U (2001)
11. Position a NEW EGR pipe gasket on the exhaust manifold.
12. Install the EGR pipe (with valve).
13. Install the following EGR pipe bolts until snug:
^
Intake manifold (1)
^
Cylinder head (2)
^
Exhaust manifold (3)
14. Tighten the EGR pipe bolts.
^
Tighten the EGR valve pipe-to-intake manifold bolts to 10 Nm (89 inch lbs.).
^
Tighten the EGR valve pipe-to-cylinder head bolts to 50 Nm (37 ft. lbs.).
^
Tighten the EGR valve pipe-to-exhaust manifold bolts to 30 Nm (22 ft. lbs.).
15. Route the electrical harness into position over the engine.
16. Connect the knock sensor harness electrical connector to the intake manifold.
17. Connect the following electrical connectors.
^
MAP sensor (1)
^
Knock sensor (2)
