C 3500 Truck 2WD V8-6.0L VIN U (2001)
Compressor Clutch: Service and Repair
With Harrison Compressor
Clutch Rotor and/or Bearing Install (HT6/HD6/HU6)
TOOLS REQUIRED
-
J 6083 External Snap Ring Pliers
-
J 33023-A Puller Pilot
-
J 41552 Compressor Pulley Puller
-
J 29886 Driver Handle
-
J 21352-A Support Block
-
J 9481-A Bearing Installer
-
J 33019 Bearing Staking Tool
-
J 33017 Pulley and Bearing Assembly Installer
-
J 8433-1 Puller Bar
-
J 8433-3 Forcing Screw
-
J 34992 Compressor Holding Fixture
NOTE: Do not support the rotor by resting the pulley rim on a flat surface during the bearing installation or the rotor face will be bent.
1. Place the pulley rotor on the J 21352-A in order to fully support the rotor hub during bearing installation.
2. Use the following tools in order to align the new bearing squarely with the hub bore:
-
The J 41552
-
The J 9481-A
-
The J 29886
3. Drive the bearing fully into the hub.
The installer will apply force to the outer race of the bearing, if used as shown.