C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
Seat Heater: Procedures
Seat Back Heater Element Replacement - Front
REMOVAL PROCEDURE
IMPORTANT: On the Escalade model prior to VIN number 2R1 18250 the seat back heater is sewn into the seat back cover. Refer to Seat Back
Cover and Pad Replacement Front. After VIN number 2R116250 the seat back heater can be replaced separate from the seat back cover refer to the
procedure below.
1. Remove the seat from the vehicle.
2. Remove the seat back trim cover.
3. Peel the seat back heater off the foam pad.
4. Disconnect the seat back heater harness.
INSTALLATION PROCEDURE
1. Connect the seat back heater harness.
2. Install the seat back heater.
3. Install the seat back trim cover.
4. Install the seat in the vehicle.
Seat Cushion Heater Element Replacement - Front
REMOVAL PROCEDURE