C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
INSTALLATION PROCEDURE
1. Install the mode actuator as an assembly with the actuator cam.
-
Line up the heater/defroster valve lever with the mode actuator cam slot.
-
Line up the A/C valve lever with the mode actuator cam.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the mode actuator mounting screw to the HVAC module.
Tighten
Tighten the screw to 1.6 N.m (14 lb in).
3. Connect the electrical connection at the mode actuator (10).
4. Install the center console duct.
5. Install the screws from the center console duct.
Tighten
Tighten the screw to 1.6 Nm (14 lb in).
6. Install the center console.
7. Install the floor air outlet dud extension (1) to the floor air duct (2).
"For a description of the RPO Code(s) shown in this article or any of the images therein, refer to the RPO Code List found at Vehicle/Application". See:
Application and ID/RPO Codes
