C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
Body Control Module: Procedures
IMPORTANT: If the module is replaced, programming the module with the proper RPO configurations must be done prior to performing the Passlock
Learn procedure.
1. Ensure that the following conditions exsist in order to prepare for BCM programming:
^
The battery is fully charged.
^
The ignition switch is in the RUN Position.
^
All accessories are turned OFF.
^
All Modules and devices are connected and functioning properly before programming.
2. Follow the SPS instructions on the Techline Terminal and scan tool to program the BCM.
3. If the BCM fails to accept the program, perform the following steps:
^
Inspect all BCM connections.
^
Verify that the SPS Techline Terminal and scan tool have the latest software version.
Passlock Learn Procedures
Refer to Programming Theft Deterrent System Components in Theft Deterrent for the appropriate learn procedure.
IMPORTANT: After programming, perform the following to avoid future misdiagnosis:
1. Turn the ignition OFF for 10 seconds.
2. Connect the scan tool to the data link connector.
3. Turn the ignition ON with the engine OFF.
4. Use the scan tool in order to retrieve history DTCs from all modules.
5. Clear all history DTCs.
