C 3500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2002)
6. Clear an area on the floor approximately 1.85 m (6 ft) in diameter for deployment of the inflator module. If possible, use a paved, outdoor location
free of activity. Otherwise, use an area free of activity on the shop floor. Make sure you have sufficient ventilation.
7. Make sure no loose or flammable objects are in the area.
8. When deploying a steering wheel module, place the steering wheel module in the center of the cleared area.
9. When deploying an IP module refer to the following instructions:
^
Place the J 39401-B (2) in the center of the cleared area.
^
Fill the deployment fixture (2) with water or sand.
^
Mount the IP module (1) in the deployment fixture (2) with the vinyl/plastic trim facing up.
^
To mount, use 4 M 6 bolts (6), nuts (8), and washers (7) to properly secure the IP module (1) to the deployment fixture (2).
^
Tighten all fasteners prior to deployment.
10. Inspect the J 38826 SIR deployment harness and the appropriate pigtail adapter for damage. Replace as needed.
11. Short the 2 SIR deployment harness (1) leads together using one banana plug seated into the other.
12. Connect the appropriate pigtail adapter (2) to the SIR deployment harness (1).
